User`s guide

12
T
h
e Basics
2
.
Use the supplied mounting bracket as a
template to mark positions for the two
mounting screws.
3.
At the marked positions, drill holes slightly
smaller than the screws.
4
.
Remove the paper backing from each washer
and stick one inside of each bracket’s ear,
aligning the washer’s hole with the bracket’s
hole.
5.
Attach the mounting bracket to your vehicle’s
surface using the supplied screws and
lockwashers.
6
.
Slide the scanner into the bracket, aligning the
scanner’s holes with the holes in the bracket,
and then screw the mounting knobs into the
scanner.
CAUTION
:
CAUTION:CAUTION
When drilling holes, be sure to avoid
obstructions behind the mounting surface.
When in doubt, consult a qualifi ed installer.
using your scanner as a base station
You can place your scanner on a desk, shelf, or
table to use it as a base station. Since the speaker
is on the bottom of the scanner, you may want to
use the mounting bracket to elevate your scanner
off the surface for better sound. Follow the mobile
vehicle mounting instructions above to affi x
your scanner to a desk, shelf, table, or other fl at
surface (except that the bracket will be below the
scanner).
CAUTION
obstructions behind the mounting surface.
When in doubt, consult a qualifi ed installer.
NOTE