User's Manual
O The POWER/BATT LOW LED will flash when the battery is low.
To turn off the intercom, rotate VOLUME clockwise until it clicks. The POWER/BATT
LOW LED turns off.
Calling Another Station
O Be sure the station you plan to use are turned on and adjusted to the desired volume.
O Be sure the channel select has been set to the channel for the station(s) you are
calling.
1. Press CALL once. The TRANSMIT LED lights. Each station that is on and set to the
selected channel and sub-tone sounds a calling tone for 3 seconds.
2. Hold down TALK key and speak in a normal voice after you hear a beep tone. When
you finish speaking, release TALK key and listen for the response.
Notes:
O Only one party can talk on a channel at a time.
O The TRANSMIT LED on the station you are using remains lit as long as you hold
down TALK or CALL.
O The RECEIVE BUSY LED lights when you are receiving a vocal message or when
you are monitoring a locked station. The RECEIVE BUSY LED will flash if the channel is
being used.
Monitoring
You can set any station so it continuously transmits sounds from the area where it is
located to another station.
O You can monitor only one station at a time.
1. Press LOCK on the station in the area you want to monitor. The TRANSMIT LED will
flash.
2. When you finish monitoring, release the lock by pressing TALK on the station in the
area you are monitoring. The TRANSMIT LED turns off.
O After pressing LOCK on a station, you cannot call or talk to that station until you press
TALK to release the lock.
Broadcasting