User's Manual
3. Replace the cover.
When the POWER BATT LOW LED flashes during the operation of the intercom,
replace the batteries.
Warning: Dispose of old batteries promptly and properly. Do not burn or bury them.
Using AC-to-DC power
Open battery compartment and remove batteries or make sure RECHARGE ON/OFF
switch is set to OFF.
Insert the barrel plug of the adapter into DC 9V jack on the back of the unit.
Plug the other end of the adapter to a standard AC outlet.
Using Rechargeable Batteries
1. Remove the battery compartment door.
2. Install the rechargeable batteries according to the polarity symbols (+ and -) marked
on the battery compartment.
3. Slide RECHARGE ON/OFF to ON.
4. Replace the cover.
Caution: Do not attempt to recharge alkaline batteries and regular batteries.
Notes:
O It takes about 10-12 hours to completely recharge the batteries.
O The built-in charger is designed for batteries with 1.2V 1500mAh.
O Once the unit has been turned on, the batteries will be automatically charged during
the transmission mode and standby.
O The battery life for rechargeable battery (Ni-MH, 1500mA) is about 37 hours .
Mounting the Intercom
You can install the stations almost anywhere and place it directly on a desk, shelf, and
table or on a wall.