User's Manual

9
Setup
b Battery Notes
Using the AC adapter overrides any installed batteries.
When the speakers POWER LED blinks, replace the batteries.
Do not burn or bury batteries. Do not puncture or crush. Do not disassemble.
Use only fresh batteries of the required size and recommended type.
Do not use batteries of different types, capacities, or chemistry.
Remove the batteries if you do not plan to use the product for an extended
time.
If the electrolyte in the cells gets on your skin, thoroughly wash with soap
and water. If in the eyes, rinse thoroughly with cool water. Immediately seek
medical attention.
4 Connect transmitter to an audio sourceConnect transmitter to an audio source
Connect the transmitter to your audio source’s left and right audio output jacks or
to its headphone jack.







1. Connect one end of the supplied audio cable to the transmitter’s audio jacks
(white plug to L AUDIO IN and red plug to R AUDIO IN).
2. Connect to your audio source’s output jacks:
Connect the white and red plugs at the other end of the cable into the
corresponding left (white) and right (red) audio jacks on your audio source.
Connect to your audio source’s stereo headphone jack:
Connect the audio cable’s white and red plugs to the white and red jacks on
the stereo side of the Æ-inch (3.5mm) supplied adapter.
If your audio source has a Æ-inch (3.5mm) headphone jack:
Insert the adapter’s Æ-inch (3.5mm) stereo plug into the headphone jack.


Audio Out
Stereo
Headphone
Jack
Æ-inch (3.5 mm)
Headphone Jack
RL