User's Manual

Setup

w Caution:

Do not connect the transmitter to your audio source’s speaker output. It could

damage the transmitter and the audio source.

If you connected the transmitter to an audio source’s headphone jack, set the

audio source’s volume control to its middle position.

5 Stereo/mono setup



For normal stereo use, set STEREO/

MONO on the back of the transmitter

to STEREO. If you are using a monaural

system, set STEREO/MONO to

MONO.

If you select STEREO:

Set SPEAKER on the back of each speaker

to either L (for the Left stereo speaker) or

R (for the Right stereo speaker).

6 Select channel

1. Set the transmitter to a frequency channel (CHANNEL 1, 2, or 3) that has no

interference.

2. Set the speaker to the same channels as the transmitter.

n Note: If you receive interference, try changing the channel number on the

transmitter and the speakers.