User's Manual

20-523 Owner’s Manual
Page 32
5. While blinks O in the Offset, if necessary press offset number and press ENTER. Make sure the entry
and if it is incorrect then press number key again to set the base frequency. After you make sure the input
then press ENTER again.
6. While blink S in the Step press /¥ and ¥/ to repeat step number indication from 25.0, 50.0 and 12.5 kHz.
Press ENTER.
7. Press PGM to enter the program mode.
Store the trunking IDs into the sub-bank in the same bank.
PROGRAMMING FLEET MAPS
You must set the fleet map if you want to receive a Motorola Type I system. Fleet maps are included along
with other information about Motorola Type I systems at www.trunkscanner.com.
Follow these steps to program a fleet map.
1. Press PGM then TRUNK.
2. For each bank you want to program, repeatedly press FUNC, /¥, or ¥/ to select the bank.
3. Press FUNC.
4. Press 8. The following display appears:
Add illust
5. Enter the size code supplied with the Type I system information, referring to the instruction that appears on
the display. If the information was not supplied, try the following common fleet maps.
Block Size Code
1 2 3 4 5 6 7 8
-----------------------------------------------------------------------------------------------------------
0 S11 S4 S4 S12 S4 S3 S10 S1
1 S11 S4 S4 - S4 S10 S10 S1
2 S11 S4 S4 S4 S12 S4 S11 S2
3 S11 S4 S4 S4 - S4 S4 S2
4 S11 S4 S4 S4 S4 S12 S4 S3
5 S11 S4 S4 S4 S4 - S4 S3
6 S11 S4 S12 S4 S4 S12 S4 S4
7 S11 S4 - S4 S4 - S4 S4
Block Size Code
9 10 11 12 13 14 15 16
0 S4 S0 S4 S0 S3 S4 S4 S3