User's Manual

20-523 Owner’s Manual
Page 16
transmissions, trunk IDs, or banks.
Assigning a Text Tag to a Channel
1. Press MANUAL, enter the channel number where you want to enter the text, then press MANUAL again.
M and the channel number appear at the upper left corner of the display (for example: M100).
2. Press PGM. M changes to P.
3. Press TEXT. The cursor appears at the 3rd line.
4. Enter the text using the numeral keys (see “Text Input Chart” on Page XX).
Note: If you make a mistake, press /¥ or ¥/ to move to the character you want to change.
For example input “HAM 6m” as follows:
• “H” is the second letter associated with 4 on the keypad. Press 4 then 2.
• “A” is the first letter associated with 2 on the keypad. Press 2 then 1.
• “M” is the first letter associated with 6 on the keypad. Press 6 then 1.
• “Space.” Press • .
• “6” is the sixth number associated with 1 on the keypad. Press 1 then 6.
• “m” is the first letter associated with 6 on the keypad. Press 6 and FUNC (for the lower case set), then press
1.
5. Press ENTER to input the text.
Assigning a Text Tag to a Bank
1. Select a channel within the desired bank by pressing MANUAL and entering the bank number (000 for
bank 0 or 200 for bank 2, for example). Press MANUAL again.
2. Press PGM.
3. Press FUNC then 7. The cursor appears at the 3rd line of the display. Enter the text using the keypad and
press ENTER.
Text Input Chart
Notes:
• To access the numbers, after you press FUNC and 6, press 1, then press the desired number you want to
enter.
• To enter a lowercase character or a character from the second set for key 0, press FUNC after pressing the
first numeral key.