User's Manual

20-466 Owner’s Manual
Page 32
Add illust
To release ID hold, press SCAN or TRUNK.
Locking Out Talk Group IDs
Note: You can only lock out talk group IDs when the scanner is in the closed mode (see “Open and Closed
Modes” on Page XX).
1. Press PROG.
2. Press TRUNK.
3. Press FUNC, /¥ or ¥/ to move the desired bank.
4. Press /¥ or ¥/ to select the ID memory.
5. Press L/OUT to lock out the ID. L appears.
6. To remove the lockout from a trunking ID, manually select the ID memory, and press L/OUT until L
disappears.
Delay function in ID indication mode.
Press FUNC then ./Delay key.
LCD indicates Use up/Down at the 1st line,
Keys to set at the 2nd line
ID delay. At 3rd line and
2.0 seconds at bottom line.
Press up or down to select None, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5 or 4.0 seconds.
Press ENTER.
Reviewing Locked-Out Talk Group IDs
Note: You cannot clear all lockouts from a talk group at the same time.
1. Press PROG then TRUNK.
2. Press FUNC then L/OUT. The locked out ID appears. If the ID memory bank has no locked out ID, you
hear the low beep tone.
3. Press FUNC then /¥ or ¥/ to select a search bank. Or, just press /¥ or ¥/ to search for any locked out IDs
in a bank.
Clearing Talk Group Ids