Manualshelf

User's Manual

ManualsBrandsRadioShack ManualsElectronicsScanning Receiver
11121314151617181920
20-466 Owner’s Manual
Page 20
5. If you want to copy same frequency which already stored then sounds notice tone 3 times after step 1,
LCD indicates the location bank number, channel number, the frequency and Dupl.f Chxxx is appeared
at the LCD bottom line.
6. If you want to copy the duplicate frequency then press ENTER or press CLEAR to cancel.
Copy the frequency into the specified bank at vacant channel
You can copy the indicated receiving frequency into specified bank vacant channel when stops search or
tune mode.
1. Press FUNC then ENTER where you want to copy the indicated frequency.
2. Bank9 store? is appeared on the LCD.
3. If you want to copy it into the bank 9 then press ENTER. If same frequency is not stored then it is stored
in the vacant channel in bank 9.
4. Or press your desired bank number to store. Then Chan Stored! Is indicated for 2 seconds. Then all the
condition such as receiving mode and delay condition are copied on the channel. After about 2 seconds
it automatically back to search mode.
5. If the frequency is already stored then Dupl.f Chxxx is appeared at the LCD bottom line.
6. If you want to copy the duplicate frequency then press ENTER or press CLEAR to cancel.
Copy the frequency into the priority channel
You can copy the indicated receiving frequency into priority channel when stop search, stop scan, manual,
tune or WX mode.
1. Press FUNC then PRI where you want to copy the indicated frequency then the frequency is copied in
priority channel.
2. It blinks Pri channel and it is stored.
SCANNING THE CHANNELS
To begin scanning channels or to start scanning again after monitoring a specific channel, press SCAN.
Note: You must store frequencies into channels before the scanner can scan them. The scanner does not
scan at empty channels.
The scanner scans through all channels (except those you have locked out) in the active banks (see
“Turning Channel-Storage Banks Off and On” and “Locking Out Channels or Frequencies” on Page XX).
Note: To change the scanning direction, press /¥ or ¥/.