User's Manual

20-466 Owners Manual
Page 13
Notes:
You can also select your desired bank and channel number by follow those steps while program mode.
1). Press FUNC then press /¥ or ¥/. The bank number moves upward (downward).
2). Press FUNC then press and hold /¥ or ¥/. The bank number moves continuously upward (downward).
3). Press PROG or /¥. The channel number moves upward one by one.
4). Press ¥/. The channel number moves downward one by one.
2. Press PROG. M changes to P.
3. Use the number keys and /DELAY to enter the frequency (including the decimal point) you want to
store.
If you make a mistake, press CLEAR to delete a single digit and press and hold CLEAR about 2 seconds
to delete all digits.
4. Press ENTER to store the frequency into the channel. The blinking cursor disappears.
Notes:
If you made a mistake in Step 3, Invalid Freq briefly appears and the scanner beeps when you press
ENTER. Starts again from Step 3.
Your scanner automatically rounds the entered frequency to the nearest valid frequency. For example, if
you enter a frequency of 151.553, your scanner accepts it as 151.550.
Press /DELAY to turn the delay function on or off. To have the scanner pause for 2 seconds on this
channel after a transmission before proceeding to the next active transmission, see Using the Delay
Function on Page XX. The scanner stores this setting in the channel.
If you are storing frequencies for an EDACS system, you must store them in logical channel number
order, with the first frequency in channel 1 for the current bank.
5. If necessary, press MODE to change the receiving mode.
6. If desired, program a text tag for the channel (see Assigning a Text Tag to a Channel).
7. The next channel in sequence is ready for programming. Press PROG and then repeat Steps 3 through
6.
以下を STORING KNOWN FREQUENCIES INTO CHANNELS の次に入れる
STORING TRUNKING FREQUENCIES INTO CHANNELS
1. Press PGM and FUNC then up or down to select desired bank to program.
2. Press TRUN to trunking mode.
3. Press MODE and selects Mo or ED.
4. Press PGM and selects the channel number where to enter with up or down key or numeric key.
5. Enter UHF trunking frequency and press ENTER.
6. Repeats step 4 and 5 to complete enter the trunking frequency group.
In above steps the same receiving mode set at above step 3 is repeated.
7. If necessary press MODE and change the receiving mode.