User's Manual

20-424 Owner’s Manual
Page 17
• You can manually select any channel in a bank, even if the bank is turned off.
• When you turn on a bank during scanning, the scanner moves to the selected bank and scan it. If
no transmission is found, the scanner continues scanning to scan through all selected banks.
MONITORING A STORED CHANNEL
You can continuously monitor a specific channel without scanning. This is useful if you hear an
emergency transmission on a channel and do not want to miss any details — even though there
might be periods of silence — or if you simply want to monitor that channel.
Follow these steps to manually select a channel.
1. Pressing
SCAN/MAN until MAN appears.
2. Enter the channel number (1–200).
3. Press
SCAN/MAN again.
CLEARING A STORED CHANNEL
If you no longer want a frequency stored in a channel (and you do not want to replace that frequency
with a different one), follow these steps to clear the stored frequency.
1. Pressing
SCAN/MAN to stop scanning.
2. To select the desired channel number, use the number keys to enter that channel number (1–
200).
3. Press
PGM.
PGM
appears.
4. Press
0 then ENT. The frequency number changes to
000.0000
to indicate the channel is cleared.
5. To clear another channel, use the number keys to enter that channel number (1–200), then press
PGM again. Or repeatedly press PGM until the desired channel number appears. Then repeat Step 4.
LISTENING TO THE MARINE BANK
To listen to the marine bank, press MAR.
MRN
appears about 2 seconds, then you hear the marine
channel 16.
To change the channel manually, press ^ or v.
To scan through the marine bank, hold down ^ or v for about 2 seconds.
MAN
disappears and
SRCH
appears. To change the scanning direction, press ^ or v.
To stop scanning the channels, hold down ^ or v for about 2 seconds.