User's Manual

20-315 Owner’s Manual
Page 29
transmission 21.4 MHz above or below the tuned frequency. This is rare, and the image
signal is usually cleared whenever there is a transmission on the actual frequency.
RESETTING/INITIALIZING THE SCANNER
If the scanner’s display locks up or does not work properly after you connect a power
source, you might need to reset or initialize the scanner.
Important: If you have problems, first try to reset the scanner (see “Resetting the Scanner”
on Page 29). If that does not work, you can initialize the scanner (see “Initializing the
Scanner”); however, this clears all information stored in your scanner’s memory.
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper clip, into the reset opening on the
side of the scanner. Then gently press the reset button inside the opening.
Note: If the scanner still does not work properly, you might need to initialize the scanner
(see “Initializing the Scanner”).
Initializing the Scanner
Important: This procedure clears all information you stored in the scanner’s memory.
Initialize the scanner only when you are sure the scanner is not working properly.
1. Turn off the scanner, then turn it on again.
2. Hold down
TUNE/CLEAR.
3. While holding down TUNE/CLEAR, insert a pointed object (such as a straightened paper
clip) into the reset opening on the side of the scanner, then gently press the reset button
inside the opening. The display should turn off.
4. When the display turns on again, release
TUNE/CLEAR.
Note: You must release the reset button before releasing
TUNE/CLEAR; otherwise the
memory might not clear.
A GENERAL GUIDE TO SCANNING