User's Manual

20-315 Owner’s Manual
Page 26
To remove the lockout from a channel, manually select that channel again, then press
L/O/L/O RVW until
L/O
disappears.
Notes:
• Your scanner automatically locks out empty channels.
• You can still manually select locked-out channels.
Locking Out Frequencies
To lock out a frequency during a one touch search or tune, press L/O/L/O RVW when the
scanner stops on that frequency. The scanner locks out the frequency then continues
searching. You can lock out frequencies in both tune and one touch bank searches.
Note: You can lock out as many as 50 frequencies during a search. If you try to lock out
more,
FLo -FULL
appears (see “Reviewing Locked-Out Frequencies” and “Removing
Lockouts From All Frequencies”).
Reviewing Locked-Out Frequencies
To review the frequencies you locked out, hold down L/O/L/O RVW for about 2 seconds
during a search, then repeatedly press ^ or v. The scanner beeps if there are no locked-out
frequencies, or
L-r
appears and the scanner displays all locked out frequencies as you
press ^ or v. When you reach the highest locked-out frequency, the scanner beeps twice
and returns to the lowest locked-out frequency.
Removing Lockouts Form All Frequencies in a One Touch Search Bank
Notes:
• These steps do not clear any lockouts in the marine and weather bank.
• If you locked out frequencies which are within the range of any of the one touch search
banks during tune, the scanner also removes those locked-out frequencies when you use
these steps. For example, if you lockout 29.000 MHz during tune, the scanner removes it
since 29.000 MHz is one of the frequencies in the ham radio service bank.
1. Hold down
L/O/L/O RVW for about 2 seconds during a search or tune.
L-r
appears.
2. While holding down
TUNE/CLEAR, press one touch search key that you want to clear the
lockout.
dEFAULt
appears.
3. Press ENT.
L-r 000.000
appears. The scanner clears any lockouts from all frequencies