User's Manual

20-315 Owner’s Manual
Page 24
WIRED PROGRAMMING
1. Turn off the scanner.
2. Connect the scanner to the PC using a PC cable.
3. While pressing
ENT and 9, turn on the scanner.
PGM
and
WirEd
appear. Then send the
data from the PC.
StArt
and the data being received by the scanner appears in the order it
is received.
Notes:
• If the scanner receives no data from the PC for more than 20 seconds or if you press any
key, wired programming stops.
• If the scanner did not receive a start bit from the PC,
StArt
does not appear.
4. When the scanner successfully receives all data,
End
and
FiniSh
appear. If the scanner
received an error while receiving data,
End
and
d-Err
appear. If the scanner received a
checksum error while receiving data,
C-Err
and a number shown next to
C-Err
indicates
the packet number where the error occurred.
Notes:
• If the scanner did not receive an end bit from the PC,
End
does not appear.
• Wired programming stops if the scanner receives an empty channel number.
SPECIAL FEATURES
SPECIAL FUNCTION
Each search band (FD/PD, AIR, and HAM) and tune has one or two corresponding channel
banks. The following table shows the search bands and their corresponding channel
banks.
Search Band Channel Bank
Fire/Police 4, 5
Aircraft 6
Ham 7, 8
Tune 9, 10
While searching any search band (FD/PD, AIR, or HAM), when you find a transmission and
if you want to program it into the corresponding channel bank, the scanner programs it into
a channel in the corresponding channel bank by pressing
ENT key.