User's Manual

20-315 Owner’s Manual
Page 21
To set the scanner to continuously scan through all channels with stored frequencies,
simply pressing
SCAN until
SCAN
and ^ appear, then the scanner begins to rapidly scan
until it finds an active frequency.
If the scanner finds an active frequency, it stops and displays that channel and frequency
number, then it automatically begins scanning again when the transmission on that
frequency ends.
Notes:
• To reverse the scanning direction, press ^ or v.
• To set the scanner to remain on the current channel for 2 seconds after the transmission
ends, see “Delay” on Page 24.
• To set the scanner to remain on the current channel, even after the transmission stops,
press
SCAN/MAN at any time during the transmission so
MAN
appears and
SCAN
disappears (see “Monitoring a Stored Channel”).
• To lock out channels so the scanner does not stop for a transmission on those channels,
see “Locking Out Channels or Frequencies” on Page 25.
TURNING CHANNEL-STORAGE BANKS OFF AND ON
Channel-storage banks (1–10) are on when they have a bar underneath them and off when
no bar appears underneath them. To turn off a channel-storage bank, press the bank’s
number key during scanning. The bar under the bank’s number disappears.
Note: The scanner does not scan any of the channels within the banks you have turned off.
To turn on a channel-storage bank (1–10) during scanning, press the bank’s number key. A
bar appears under the bank’s number.
Notes:
• You cannot turn off all banks. There must be at least one active bank.
• You can manually select any channel in a bank, even if the bank is turned off.
• When you turn on a bank during scanning, the scanner moves to the selected bank and
scan it. If no transmission is found, the scanner continues scanning to scan through all
selected banks.
MONITORING A STORED CHANNEL