User's Manual

3. Connect the supplied AC adapter’s barrel plug into the DC 12V jack, then connect the
adapter’s AC plug to a standard AC outlet.
Cautions:
o You must use a Class 2 power source that supplies 12V DC and delivers 120 mA. Its
center tip must be set to positive and its plug must fit the receiver’s DC 12V jack. The
supplied adapter meets these specifications. Using an adapter that does not meet these
specifications could damage the receiver or the adapter.
o Always connect the AC adapter to the receiver before you connect it to AC power. When
you finish, disconnect the adapter from AC power before you disconnect it from the receiver.
Connecting an IR Repeater
You can connect the supplied IR repeater when you need to place the receiver next to your
audio/video equipment instead of in front of it, or if your requirement is located inside a closed
cabinet.
You can connect the supplied IR repeater when you need to place the receiver next to your audio
Follow these steps to connect the IR repeater.
1. Insert the repeater’s plug into the receiver’s 1/10-inch (2.4 mm) IR OUT jack.
2. Then position the repeater cord’s LED so the VCR’s remote sensor can pick up the signal it
emits.
Notes:
o Do not place it directly in front of the remote sensor.
o You can mount the IR repeater using its adhesive back to hold it steady.
Installing the Transmitter
Follow these steps to install the transmitter.
1. Place the transmitter away from the audio/video equipment and the extender’s receiver (in
another room, for example) and position it:
o Within 100 feet of the extender’s receiver
o Within 20 feet of your remote control
o With transmitter’s front facing your remote control
2. Connect the supplied AC adapter’s barrel plug into the transmitter’s DC 12V jack, then
connect the adapter’s AC plug to a standard AC outlet.
Caution: You must use a Class 2 power source that supplies 12V DC and delivers 120 mA.
Its center tip must be set to positive and its plug must fit the transmitter’s DC 12V jack. The
supplied adapter meets these specifications. Using an adapter that does not meet these
specifications could damage the transmitter or the adapter.