Installation guide

D6600 NetCom
Overview
D6600 NetCom System Guide
© 2004 Bosch Security Systems Page 7 4998122712D
2.0 D6600 NetCom Overview
The D6600 NetCom System supports data network communications.
NetCom allows the D6600 Receiver to connect to Ethernet networks and
process messages both to and from most networks using UDP/IP protocol.
Connection to a data network can be implemented through the use of the
COM4 and/or a COM1 connection from the D6600 Receiver to the D6680
Network Adapter. Reports from alarm control panels via phone lines and/or
Ethernet data networks can be sent to the D6600 Receiver and on to the
central station automation software. Alarm control panels can be monitored
on the network for their status.
Figure 1: D6600 Communications
Receiver/Gateway
The D6600 Software can be upgraded through any network connection. The D6600 can be remotely programmed
through the D6200 Programming/Administration Software.
Bosch Security
Systems part
number
Application description
D6680 D6600 Ethernet Network Adapter
The D6600 has two COM ports on the back
available for network communication connections
– COM4 and the optional COM1. The D6600
requires a separate D6680 Network Adapter for
each COM port to be used in order to interface
with an Ethernet network. Most applications will
not initially require that both COM ports be used.
Table 3: Network Adapters Part Numbers
All Alarm Panels to be used with the D6600 NetCom System (from Bosch Security Systems or other manufacturers) must
have an interface similar in function to the Bosch Security Systems D6680 Network Adapter to allow for network
reporting. One method of interfacing an Alarm Panel (Bosch Security Systems or from other manufacturers) to a
network is to use the patented Bosch Security Systems C900TTL-E Dialer Capture Module/network adapter.**
Note: For panel manufacturers other than Bosch Security Systems, refer to the specific panel installation guide for
proper wiring, mounting and installation instructions.
The C900TTL-E module will work with almost any Alarm Panel (Bosch Security Systems or other manufacturer) that
uses a standard digital dialer utilizing one of the following industry standard formats:
• All Radionics Modem formats
• DTMF
• DTMF (where dialer retransmits quickly)
• BFSK (2300 Hz ACK & 1400 Hz ACK Tone)
• FBI Superfast DTMF (2300 Hz & 1400 Hz
ACK Tone)
• Pulse 3/1, 3/1 Checksum (2300 Hz &
1400 Hz ACK Tone)
• Pulse 4/2 (Long 2300 Hz & Long 1400 Hz
ACK Tone)
• SIA Bell 103 (110/300 baud, 2016 Hz ACK
Tone)
• ADT-SIA
• Telim
• Robofon
• SIA Bell 103 (110/300 baud, 2083 Hz ACK
Tone)
• SIA V.21 (110/300 baud)
• Seriee DTMF
• Seriee FSK