Installation guide

D6600 NetCom
Operation
D6600 NetCom System Guide
© 2004 Bosch Security Systems Page 15 4998122712D
10.
After the reboot is completed, you should perform the following check to see if the previous procedures
were correctly entered.
11.
Open the Run dialog box by selecting Start Programs
Accessories Command Prompt.
A command prompt window appears.
Type ipconfig and press [ENTER].
12.
The IP configuration for the PC is returned. The
following information is displayed:
Connection-specific DNS Suffix
IP Address
Subnet Mask
Default Gateway
Note: Verify the IP address, subnet mask, and whatever other information is listed. (This information should
match the IP and subnet mask you assigned to this computer in the previous steps).
If you have chosen to program the D6600’s initial NetCom parameters via the direct null modem serial connection, then
continue on with the following steps. These steps are ONLY necessary if the host computer running the D6200 Software is
connected to the D6600’s COM4 port via a direct NULL modem serial cable!
13.
Click Start
Settings
Control Panel
to open the
Control Panel.
14. Once the Control Panel window opens, double-click on the
System icon.
15.
The System
Properties
window opens
to show a row
of five tabs.
16.
Click on the Hardware tab.
17.
Click the Device Manager button.