Installation guide
D6600 NetCom
Operation
D6600 NetCom System Guide
© 2004 Bosch Security Systems Page 13 4998122712D
If you have chosen to program the D6600’s initial NetCom parameters via the direct null modem serial connection, then
continue on with the following steps. These steps are ONLY necessary if the host computer running the D6200 Software is
connected to the D6600’s COM4 port via a direct NULL modem serial cable!
11. In Microsoft
®
Windows
®
operating system, click on
the Start button and then go to Settings and Control
Panel.
12. Once the control panel is open, find
and double-click on the “System” icon
to launch the System control panel.
13. From the Device Manager tab, select Ports. Highlight
the COM port (usually COM1) used to connect the
D6200 Software to the D6600 COM4 port via a direct
connect NULL Cable.
14. Highlight the port icon and
then click on the
"Properties…" button.
15. Under the Port
Settings tab,
select 38400
bits per second
baud rate and
then click OK.
3.1.2 Windows 2000/XP/NT
If the host computer is running Windows 2000/XP/NT and is new to the network the following steps MUST be
performed:
Note: Even though the screen captures are specific to Windows 2000, they are similar for Windows XP and NT.
1.
Click on Start Settings Control Panel.
2. Once the control panel is open, find and
double-click on the “Network and Dial-up
Connections” icon to launch the Network
and Dial-up Connections control panel.
3. Find and double-click on the “Local Area Connection”
icon.