Installation guide

D6600 NetCom
Operation
D6600 NetCom System Guide
4998122712D Page 12 © 2004 Bosch Security Systems
5. Select the IP address tab, then click the "Specify an IP address" radio
button.
6. Enter an IP address and subnet mask
for the network you will be setting
up, such as 202.96.168.1.
Note: If you have any questions regarding the assignment of the IP
address or subnet mask, see the network administrator!
All devices that will be on this network must have the correct subnet mask and
gateway entered.
7. Some files may have to be copied to the computer.
This may require Microsoft
®
Windows
®
operating
system disk for the appropriate version you are using.
8. After copying the files, the PC may have to be restarted. If so, connect the Host PC's NIC card to the
network (hub) and restart the PC.
9. After the reboot is completed, you should perform the following check to see if the previous procedures
were correctly entered.
Open a MS-DOS window by selecting Start
Programs MS DOS Prompt:
10. Once the DOS Window appears,
type the command winipcfg
[ENTER].
The IP Configuration window should appear:
Note: Make sure that the Network Adapter is selected in
the first window, not a PPP adapter. Verify the IP
address, subnet mask, and whatever other
information is listed. (This information should
match the IP and subnet mask you assigned to this
computer in the previous steps).