Installation guide

D6600 NetCom
C900TTL-X Configuration
D6600 NetCom System Guide
© 2001 Radionics Page 81 46542C
16.
You should then see:
Press Enter to accept the default of (00). If it doesn't show that,
type 00 [ENTER] to change it.
17.
You should then see:
Therefore you should type 7700 [ENTER]
18. You should then see:
Press [ENTER] to accept the default of (CC). If it doesn't show
that, type CC [ENTER] to change it.
19. You should then see:
Type 01 [ENTER]. C900s are DATAGRAM type 01.
20.
Enter the remote IP address (this will
be the IP address used by the D6680
that the C900 being configured will
report to.
Type the remote IP address in the form of 000.000.000.000 [ENTER] to change it.
21. You should then see:
Press [ENTER] to accept the default of (07700). If it doesn't
show that, type 07700 [ENTER] to change it.
22. You should then see:
Press [ENTER] to accept the default of (00). If it doesn't show
that, type 00 [ENTER] to change it.
23. You should then see:
Press [ENTER] to accept the default of (00). If it doesn't show
that, type 00 [ENTER] to change it.
24. You should then see:
Press [ENTER] to accept the default of (00). If it doesn't show
that, type 00 [ENTER] to change it.
25.
Press [9] [ENTER] to save changes and exit the Telnet session.
A message is displayed that the connection was lost. Click OK
and close the Telnet window.
Configuration of the C900TTL-X Dialer Capture Module is complete. Perform this procedure for any additional
C900TTL-X’s you may have.