Installation guide
D6600 NetCom
C900TTL-X Configuration
D6600 NetCom System Guide
© 2001 Radionics Page 79 46542C
6. Click on the Connect menu and then Remote System selection again.
Enter 9999 into the Port field, leaving the Host Name and TermType
fields the same. Click the Connect.
7. The program will prompt you to press [ENTER] by
displaying "Press Enter to go into setup mode."
Press [ENTER].
If you do not press [ENTER] within 5 seconds of seeing the above message, you
will be disconnected. If this occurs, simply return to Step 1 (in this section).
8.
If you pressed [ENTER] within 5
seconds, then you should see the
following screen (See Figure 38: ).
Figure 38: Telnet Session
9. Press [0] + [ENTER] to set up the basic Server Configuration.
You are now required to enter the desired IP address.
If the C900TTL-X Dialer Capture Module has been programmed with an IP address in the past, it will be
displayed in parentheses (as shown to the right).
For example, if this D6680 Network Adapter was originally programmed to IP address 190.200.128.152,
we would be changing it to address 190.200.128.219.
10. To properly program the IP
address 190.200.128.219, the
following keys would be
entered:
190 [ENTER] 200 [ENTER] 128 [ENTER] 219 [ENTER]
Note: REMEMBER THAT THE IP ADDRESS USED IN THIS EXAMPLE WILL NOT BE THE SAME AS THE
NUMBERS YOU ARE USING. THIS IS FOR DEMONSTRATION ONLY!