Installation guide
D6600 NetCom
RAM IV NetCom Programming
D6600 NetCom System Guide
© 2001 Radionics Page 65 46542C
Answer Disarmed
Default: 7
Selections: 0 – 15
This item determines the number of rings when the External Modem will automatically answer a call if any area is
Perimeter Armed or Disarmed.
0 No answer when any area is Perimeter Armed or Disarmed.
0-15 The panel answers the phone after the specified number of rings when any area is
Perimeter Armed or Disarmed.
RAM Line Monitor
Default: No
Selections: Yes or No
This item is not yet implemented. Keep this item set to No.
Seize Relay
Default: No
Selections: Yes or No
This item is not yet implemented. Keep this item set to No.
Modem Init String
Default: ATEO
Selections: A – Z (caps only), 0 – 9, (space), ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _
This item determines what Initialization String the panel will send to the External Modem when the panel is
powered up.
Programming
Note
0101
0101
0101
This item can only be programmed successfully from RAM IV. The D5200 Programmer does not
allow certain characters as noted above.
RAM Dial String
Default: ATDT
Selections: Not yet implemented
This item is not yet implemented.
6.1.3 Enhanced Communications
Enhanced Communications is the ability to communicate by some other means than the standard digital dialer.
In this section, programmable parameters allow you to define up to four separate Enhanced Communication
paths to which events can be routed. To route an event (such as an alarm or trouble) to an Enhanced
communication path, additional programming must also be completed in the Routing and Enhanced Routing
sections.
Enhanced Comm
Default: No
Selections: Yes or No
This item determines if the panel will allow Enhanced communications over the SDI bus.
Yes
♦THIS IS THE SETTING NECESSARY FOR NetCom NETWORK COMMUNICATIONS
No Do not enable Enhanced communications over the SDI bus.