Installation guide
D6600 NetCom
RAM IV NetCom Programming
D6600 NetCom System Guide
46542C Page 64 © 2001 Radionics
RAM IP Address 1
Default: 0
Selections: 0 – 255
This prompt and the next 3 prompts will determine the IP
address for RAM IV.
An IP Address consists of four fields. Each field has a range of
0 – 255. As an example, an IP Address is expressed as
110.227.64.190. The D5200 Programmer has split the IP
Address into four programmable fields. Be sure you contact
your network administrator to find out which IP Address your
RAM IV computer is connected to.
Note: Set this item to 0 if Enable Ext Modem is set to Yes.
110.227.64.190
RAM IP Address 1
RAM IP Address 2
RAM IP Address 3
RAM IP Address 4
Figure 24: RAM IP Address Prompts
0 – 255 Enter the first three digits of the IP Address. Leading zero’s are not required if the field is
one or two digits in length.
RAM IP Address 2
Default: 0
Selections: 0 – 255
See RAM IP Address 1.
RAM IP Address 3
Default: 0
Selections: 0 – 255
See RAM IP Address 1.
RAM IP Address 4
Default: 0
Selections: 0 – 255
See RAM IP Address 1.
Enable Ext Modem
Default: No
Selections: Yes or No
Setting this item to Yes instructs the 9000 Series Control/Communicator that SDI Address 88 is enabled for use
with an External Modem. For further information on Local RAM IV programming, please refer to the RAM IV
Operation Manual (P/N: 38849).
Note: Setting this item to YES disables Enhanced Communication and SDI RAM for use over a Local or Wide Area
Network.
Yes Enable SDI Address 88 for use with an External Modem.
No Disable SDI Address 88 for use with an External Modem.
Answer Armed
Default: 7
Selections: 0 – 15
This item determines the number of rings when the External Modem will automatically answer a call if all areas
are in the Master Armed state.
0 No answer when all areas are Master Armed.
1-15 The panel answers the phone after the specified number of rings when all areas are Master
Armed.