Installation guide

D6600 NetCom

D9133TTL Configuration

D6600 NetCom System Guide

Click on the Connect menu and choose Remote System again.

Enter 9999 into the Port field, leaving the Host Name and TermType

fields the same. Click the Connect.

8. The program will prompt you to press [ENTER] by

displaying "Press Enter to go into setup mode."

Press [ENTER].

If you do not press [ENTER] within 5 seconds of seeing the above message,

you will be disconnected. If this occurs, simply return to Step 1 (in this

section).

9. If you pressed [ENTER] within 5

seconds, then you should see the

following screen (See Figure 21:

Telnet Session).

Figure 21: Telnet Session

10.

Press 0 [ENTER] to set up the basic Server Configuration. You

are now required to enter the desired IP address.

If the D9133TTL-E Network Interface module has been programmed with an IP address in the past, it will

be displayed in parentheses (as shown to the right). For example, this D9133TTL-E was originally

programmed to IP address 190.200.128.152. We are now changing it to address 190.200.128.220.

11. To properly program the IP address

190.200.128.220, the following keys

would be entered:

190 [ENTER] 200 [ENTER] 128 [ENTER] 220 [ENTER]

Note: REMEMBER THAT THE IP ADDRESS USED IN THIS EXAMPLE WILL NOT BE THE SAME AS THE

NUMBERS YOU ARE USING. THIS IS FOR DEMONSTRATION ONLY!

REMEMBER THAT THE IP AND MAC ADDRESS USED IN THIS EXAMPLE WILL NOT BE THE SAME

AS THE NUMBERS YOU ARE USING. THIS IS FOR DEMONSTRATION ONLY!