Installation guide

D6600 NetCom
D6200 Programming Software Overview
D6600 NetCom System Guide
46542C Page 50 © 2001 Radionics
4.12 Account Status Procedures
The procedures for Account Status are searching, sorting, receiver-panel communication status, time of status
change and IP Address status.
4.12.1 Searching the Account Database
To locate a particular account in the current database, click on the NetCom menu, then select Account
Database Configuration. The user can choose to search the database by a key field, by a specific IP address,
or by combined options.
To search the database by a key field, select a particular field from the Search By box. Enter the keyword in the
Find Value box and then click Go. To return to the entire database and to clear any previous queries, click on the
List All button.
To search the database by a specific IP Address, enter an IP address and then click on the adjacent GO button.
To return to the entire database and to clear any previous queries, click on the List All button.
To search the database by combined options, enter information in one or more of the boxes. Once all of the
desired search criteria has been entered, click on the Search button. To return to the entire database and to
clear any previous queries, click on the List All button.
4.12.2 Sorting Database Information
To sort database information, click on the NetCom menu, then select Account Database Configuration. Click
on the desired heading by which the program should sort the database. The user can choose to sort the
database by IP address, Virtual Account, Virtual Line, Enable, Poll Rate, Status, or Status Changed Time.
4.12.3 Status
Under Account Database Configuration, this value will be either be a “1” or a “0”. A “1” will indicate that the
connection is good between the receiver and that particular panel. A “0” will indicate that the receiver is no longer
receiving polls from that particular panel.
For both “Status” and “Status Changed Time” the database must be read into the D6200 for an up to
date reading. After the database has been loaded from the D6200 to the D6600, all the status fields
will be blank until a change on the network occurs.
4.12.4 Status Changed Time
Under Account Database Configuration, this indicates the time at which the status changed for this panel, not
when the database is read into the D6200.
4.12.5 Show Account Status
To view the account status and status changed time for corresponding IP Addresses, click on the NetCom
menu, then select Show Account Status. For up-to-date account status, the database must be read into the
D6200 from the D6600.
4.13 C900 Commands
The D6200 Programming Software will send C900 Commands to the
D6600 Receiver/Gateway. The commands will be held by the D6600
until a poll is received from the appropriate C900 Interface Module.
Once that happens, the command(s) will be sent on to that C900.
To access the C900 Control Commands, click on the NetCom menu,
then select C900 Control Commands.