Installation guide
D6600 NetCom
D6200 Programming Software Overview
D6600 NetCom System Guide
© 2001 Radionics Page 49 46542C
4.11.5 Copying Account Information
1. Select NetCom, then select Account Database Configuration.
2.
Highlight the appropriate account and then click
Copy.
This will retain all account information except the
IP address.
The user must enter a new IP address pertaining
to the new account.
3. The Settings tab will automatically open.
Enter the IP address under the Settings tab. See
Section 4.11.3 Adding an Account in the
Database.
4.
Click OK and the new account should appear in
the database.
This tool is extremely useful when account information
is the same for several different panels.
4.11.6 Deleting an Account from the Database
1. Click on the NetCom menu, then select Account Database
Configuration.
2. Highlight the appropriate account and then click Delete.
3.
A window will pop up to confirm the
deletion.
Click Yes or No
4. Click OK.
After the completion of any changes to the account database, you must first save the file to the D6200
hard drive, then upload the account database file to the D6600. The new account database becomes
active in the receiver after the upload is complete.
To do this, click on NetCom then Load Account
Database Configuration to D6600.