Installation guide

D6600 NetCom

D6200 Programming Software Overview

D6600 NetCom System Guide

4. Fill in the appropriate information for each

field by typing the information and using

the [TAB] key to move to the next field.

When finished, click OK.

See Table 15 for a description of the

fields in the Settings tab.

Field Description

IP Address Enter the IP Address of the panel.

This is where the account number of the panel can be placed as it is identified in

the automation system.

The number of digits entered for the Virtual Account number

must match the number of digits in the dialer account number.

For example: if a panel account number is 1234, then the virtual

account number must consist of four digits. If the panel account

number is 12345678, then the virtual account number must

consist of eight digits. You cannot use alpha characters in the

virtual account.

Virtual Account

A Virtual Account number is used to identify which panel has lost its network

connection when an “Off Normal Status” message appears. If no Virtual Account

number has been entered, the default message “ACT0000 Off Normal Status”

message appears. In this case the only way to identify which panel has lost its

network connection is to read through the D6200 and view the status of the

panels in the account database.

Enable Communication

“0” disables and “1” enables communication between the alarm panel and the

receiver.

Virtual Line Enter this line number only if it is part of the alarm panel account number. If the

line number is not used, select 0 (zero).

Priority Level Reserved Feature.

Panel Poll This is a range of zero to 300 seconds in 30 second intervals. Enter the value

that is closest to the number of seconds desired for polling the receivers. A

selection of “0” will result in no poll being sent. “1” will send a poll every 30

seconds, “2” will send a poll every 60 seconds. “3” = 90 seconds, “4” = 120

seconds, etc.

Receiver Poll Reserved Feature.

Redirect Automation Reserved Feature.

Backup Automation Reserved Feature.

Table 15: Settings Tab Field Definitions