Installation guide
D6600 NetCom
D6200 Programming Software Overview
D6600 NetCom System Guide
46542C Page 46 © 2001 Radionics
Column Description
IP Address The IP address of the panel.
Virtual Account The account number of the panel as it is identified in the automation system.
Virtual Line Enter this line number only if it is part of the alarm panel account number. If the line
number is not used, enter “0”
Enable “0” disables and “1” enables communication between the alarm panel and the receiver.
Selection Seconds
0 0
1 30
2 60
3 90
Poll Rate This is a range of zero to 300 seconds in 30 second
intervals. Enter the value that is closest to the number of
seconds desired for polling the receivers.
4 120
Status The current communication status between the panel and D6600.
(0 = panel is OFFLINE, 1 panel is ONLINE).
Status Changed Time The time and the date status of the IP address were changed/updated.
Table 14: Account Database Column Definitions
3.
Click Add to add an additional account.
Fill in the appropriate information for each
field by typing the information and use the
Tab key to move to the next field.
When finished, click the Settings tab.