Installation guide
D6600 NetCom
Configuration of the D6680 Network Adapter(s)
D6600 NetCom System Guide
46542C Page 26 © 2001 Radionics
Number of
Host Bits
Netmask
Number of
Host Bits
Netmask
Number of
Host Bits
Netmask
1 255.255.255.254 11 255.255.248.0 21 255.224.0.0
2 255.255.255.252 12 255.255.240.0 22 255.192.0.0
3 255.255.255.248 13 255.255.224.0 23 255.128.0.0
4 255.255.255.240 14 255.255.192.0 24 255.0.0.0
5 255.255.255.224 15 255.255.128.0 25 254.0.0.0
6 255.255.255.192 16 255.255.0.0 26 252.0.0.0
7 255.255.255.128 17 255.254.0.0 27 248.0.0.0
8 255.255.255.0 18 255.252.0.0 28 240.0.0.0
9 255.255.254.0 19 255.248.0.0 29 224.0.0.0
10 255.255.252.0 20 255.240.0.0 30 192.0.0.0
31 128.0.0.0
Table 8: Netmask Address
14.
You will be prompted to change the TELNET password, press [N] for the default of "No". This screen will
now show the Setup Mode screen you saw previously in Figure 13.
Be careful NOT to enter a password into the D6680 Network Adapter by accident or select [Y] to
change the password. If you do, do not lose the password. Otherwise, you will not be able to re-
enter a TELNET programming session with the D6680. The unit will have to be sent back to the
factory and reconditioned before it will be able to receive another TELNET session.
15.
Now press [1] [ENTER] to go into setup Channel 1
configuration. The following will be displayed:
You must set the baud rate of the D6680 to 38400.
Enter 38400 [ENTER] to change it.
16. You should then see:
Press [ENTER] to accept the default of (4C). If it doesn't show that, type 4C [ENTER] to change it.
17. You should then see:
Press [ENTER] to accept the default of (00). If it doesn't show that, type 00 [ENTER] to change it.
18. You should then see:
For the Port number, type a number that is between 2000 and 10000 followed by [ENTER].
The port number can be compared to a phone extension on a PBX system. For our example we will be
using D9133TTLs and C900TTLs all set up on port 7700.
Be sure to set the port number for Channel 1 different from the port number for Channel 2 (displayed
in the TELNET configuration screen).
19. You should then see:
Press [ENTER] to accept the default of (CC). If no default is shown, type CC [ENTER] to change it.
20. You should then see:
Type 00 [ENTER]