Boxer Quick start guide WWW.RADIOMASTERRC.
Introduction Thank you for purchasing the RadioMaster Boxer 2.4g remote control system. The system is versatile and can be used by beginners and professionals. In order to ensure the correct and safe use of this product, please read this manual carefully before use. Due to constant improvements in software and hardware this manual may change over time. The information contained in this manual is subject to change without notice. Visit our website for the most up to date information.
Remote control overview Antenna S1 Dial Trainer Port SE Latching switch Type-C Data Port S2 Dial Headphone Jack SF Momentary switch SA 2 Position SD 2 Position SB 3 Position Speaker SC 3 Position Left Gimbal Right Gimbal Power Button Lanyard Loop 6 Pos Buttons SYS Button RTN Button Trim Buttons MDL Button PAGE> Button PAGE< Button Scroll wheel TELE Button LCD Screen TYPE-C Charger Port Batteries and charging Boxer has a built-in USB-C charging function for 3.7V lithium batteries.
Model and protocol selection (multi-protocol module) The Boxer comes with 4in1 or CC2500 multi-protocol internal RF module, which is compatible with several different protocols. To view the latest list of all compatible protocols, please visit https://www.multi-module.org/ Please note that new protocols will be constantly updated and added to the latest firmware. Some new protocols may require firmware upgrades.
Specifications Size: 235*178*77mm Weight: 532.5g Frequency: 2.400GHz-2.480GHz Internal RF Options: CC2500 multi-protocol / 4-in-1 multi-protocol / ELRS 2.4GHz Supported protocols: Module dependent Transmitting Power CC2500 and 4IN1: Max 20dBm Transmitting Power ExpressLRS: Max 30dBm (international) / Max 20dBm (EU LBT) Cooling fan: Built in (ELRS version) Voltage Range: 6.6-8.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
