User Manual

Radiolink Electronic Ltd
www.radiolink.com
14
REVERSE: Defines the relationship between the transmitter controls and the receiver output for channels with
option of NORM and REV. Refer to 3.3.2-REV (P8) for more details .
SUB-TRIM: Makes small changes or corrections to the neutral position of each servo. Refer to 3.3.2-SUB (P9)
for more details .
END POINT: Sets the range of each channel(in percentage);
The most flexible version of travel adjustment is available. It independently adjusts each end of each individual
servo’s travel, rather than one setting for the servo affecting both directions. Refer to 3.3.2-EPA-L &EPA-R (P9)
for more details .
FAIL SAFE: Sets responsive action of model in case of signal loss or low Rx voltage(in percentage).
Refer to 3.3.2-F/S (P9) for more details .
AUX-CH: Defines the relationship between the transmitter controls and the receiver output for channels 5-8.
Refer to 3.3.4(P11) for more details .
DELAY: Adjust the ratio between the position of servos and the actual operation. Refer to 3.3.2-DELAY (P9) for
more details .
TX-ALARM: In the computer parameter setup software, the low voltage alarm value of T8S is 3.7V by default
and can be personalized. When the transmitter voltage is lower than the value set, T8S will make D sound to
warn.
STK-MODE by default
1 is throttle at right while 2 is throttle at left. 3 is throttle at right for toys while 4 is throttle at left for toys.
VERSION
The numbers mean different firmware versions which can be upgraded. The detailed steps of firmware
upgrade please refer to Chapter 2.
4.2.2 ADVANCED Menu
There are six parameters setup ”D/R” “ATTITUDE” “ELEVON” “V-TAIL”PROG.MIX1/PROG.MIX2 as below
shown， please refer to 3.3.3 (P9-10) and 3.3.4(P10-11) for more details..