User Manual

Radiolink Electronic Ltd
www.radiolink.com
13
4.2 Parameters Setup Menu
READ: T8S data will be read and displayed on computer when click “READ”and two D sounds will be heard.
LOAD: The data file in TXT format saved will be loaded in the software.
UPDATE: Modify the data as wish or load the data which is saved as file then click “UPDATE”to change the
parameter in T8S. (two green LEDs on the right will flash once with one D sound).
SAVE The data read or set will be saved as TXT file in the computer. This is very helpful if there are several
sets of radio data need to be saved or if one set of parameters need to be copied in different radios.
Parameters Setting Steps
 When parameters need to be modified, click READ first to input the original data into the software, then
modify as wish and click UPDATE to output the modified data to T8S.
 When parameters SAVE as TXT file need to be input, click LOAD first to input the saved data into the
software then click UPDATE to copy them to T8S.
4.2.1 BASIC Menu
There are 6 parameters to setup: “REVERSE””SUB-TRIM””END POINT””FAIL SAFE””AUX-CH””DELAY”