User Manual

Radiolink Electronic Ltd
www.radiolink.com
12
THROTTLE CUT Setup
This function is achievable with T8S programmable mix controls setting.
In SYSTEM Menu, turn on the Mix Control, set Master as CH1 while Slave as CH8 with the OFFS value as
-100. Then in ADVANCED Menu, turn on the D/R MIX function, set CH as CH3 and the DOWN value as 0.
Then toggle the CH8 Toggle-Switch to the right most and the setting is complete.
RESET
This function is to restore the factory setting when necessary.
Chapter 4 T8S Parameters Setup via Computer
4.1 Software Installation and Connect
Connect the computer and the T8S with an android USB data cable
Open the parameter setup software in the downloaded file
，
then power on T8S
Choose Port Number( COM port will be automatic identified when connected), setting baud rate: 115200,
8-1-None(8 data bits, 1 stop bit, no parity check), click OPEN to connect.
Note When click OPEN to connect, the SETTING parts mentioned above will turn grey and can’t be changed
and PARAMETERS at bottom right will be displayed