User Manual

Radiolink Electronic Ltd
www.radiolink.com
13
4.2 Parameters Setup Menu
READ: T8FB data will be read and displayed on computer when click “READ”. The two LEDs at the rightmost
will flash once at the same time with two D sounds .
LOAD: The data file in TXT format saved will be loaded in the software.
Click “browse” to select the preferred data file and load it into the
software.
UPDATE: Modify the data as wish or load the data which is saved as
file then click “UPDATE” to input the new parameter into T8FB. (two
green LEDs at the rightmost will flash slightly with two D sounds. Click
at least four times to make sure the modified data is well input or
repower on the T8FB to double confirm if the data is well input).
SAVE: The data read or set will be saved as TXT file in the computer. This is very helpful if there are several
sets of radio data need to be saved or if one set of parameters need to be copied in different radios.
Parameters Setting Steps
 When parameters need to be modified, click READ first to input the original data into the software, then
modify as wish and click UPDATE to output the modified data to T8FB.
 When parameters SAVE as TXT file need to be input, click LOAD first to input the saved data into the
software then click UPDATE to copy them to T8FB.
4.2.1 BASIC Menu
There are 6 parameters to setup: “REVERSE”” SUB-TRIM”” END POINT”” FAIL SAFE”” AUX-CH”” DELAY”