Manual

RadioLink Electronic Ltd
www.radiolink.com
23
2.17 Channel 3 Position "AUX"
The channel 3 and channel 4 servo position can be set from the transmitter. When CH3 is assigned to the 3
rd
channel key, this setting is linked to the key. When CH3 and CH4 is not assigned to the 3rd channel key, it can
be set with this screen.
You can also set the CH3 and CH4 as VR at the same time, or SW.
Channel 3 position (POSI)
SW(LOCK) or VR(RATE)
Channel 4 position (POSI)
SW(LOCK) or VR(RATE)
(1) Enter the function menu and use “Dec(-)” or “Inc(+)” button to
access AUX function.
(2) Press “Enter” button to get into CH3 or CH4 function interface.
(3) Use “Dec(-)” or “Inc(+)” button to select Channel setup item.
Use “Dec(-)” or “Inc(+)” button to select POSI, press“Enter”key and the value will blink, use “Dec(-)” or “Inc(+)”
button to select “VR” or “SW”.
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
2.18 Model Name "NAME"
RC4GS stores model memories for ten models. Each model
memory can be named separately according to user’s
requirement.
Factory default name: MODEL1
(1) Enter the function menu and use “Dec(-)” or “Inc(+)” button to
access NAME function.
(2) Press “Enter” button to get into NAME function interface, the
first character of current name will blink, and the blinking character
can be reset. The common use characters appear at the bottom of
the screen, use “Dec(-)” or “Inc(+)” button to choose the character you desired.Press“Enter” button again, the
next character of current name will blink. Reset other characters of current name in same manner.
(3) After accomplishment of naming, all characters of current name will stop blinking, the new name will be
stored automatically.
(4) When ending setting,return to the initial screen by pressing“Exit”button twice.(the new setting model name
will appear on the initial screen)
2.19 Low Voltage Alarm
The transmitter’s low voltage alarm adjustable, it depends on what kind
of battery, the 4.6V is may cause the battery over discharge and
damage the battery. So you can set transmitter’s warning voltage when
you use different battery.
There are four options you can choose:
Li2S-7.2V
Li3-10.8V
Ni4S-4.6V
ALARM: adjustable 4.0V to 16.0V