Manual

RadioLink Electronic Ltd
www.radiolink.com
16
CH4: Channel4
Sub-trim
ST: -100~0~+100
TH: -100~0~+100
CH3: -100~0~+100
CH4: -100~0~+100
Initial value : 0
(1) Enter the function menu and use “Dec(-)”or “Inc(+)” button to access SUBTR function.
(2) Press “Enter” button to get into SUBTR function interface.
(3) Use “Dec(-)” or “Inc(+)” button to select ST channel, press “Enter”key, and the initial value of ST will blink.
Use “Dec(-)” or “Inc(+)” button to adjust the center.
(Note: In the interface of adjusting the value, return to the initial value "0" by pressing “Dec(-)” and “Inc(+)”
buttons simultaneously for about 1 second.)
(4) Press “Enter” key, the adjusted value stops blinking, now the center of ST has been adjusted.
(5) TH channel and CH3 can be set similarly.
(6) When ending setting, return to the initial screen by pressing “Exit” button twice.
2.13 Servo Reverse "REV"
Servo operation reversing
This function reverses the direction of operation of the servos related to transmitter steering, throttle, channel
4 and channel 3 operation.
Channel
ST: Steering
TH: Throttle
CH3: Channel3
CH4: Channel4
(1) Enter the function menu and use “Dec(-)” or“Inc(+)” button to
access REV function.
(2) Press “Enter” button to get into REV function interface.
(3) Use “Dec(-)” or “Inc(+)” button to select ST channel, press
“Enter”key, and the “NOR” will blink.
(4) Press “Enter” key, the “NOR” stops blinking, Use “Dec(-)”or“Inc(+)”button to reverse the ST servo
operation direction.
(5) TH channel, CH3 and CH4 channel can be set similarly.
(6) When ending setting, return to the initial screen by pressing “Exit” button twice.
2.14 Steering Dual Rate/Throttle Dual Rate "D/R"
Dual rate
The steering left and right servo travels are adjusted
simultaneously. When you want to increase the servo travel,
adjust the + side. When you want to decrease the servo travel,
adjust the - side.