Manual

RadioLink Electronic Ltd
www.radiolink.com
7
operation amount adjustment, and channel 3 servo up side/down side operation amount adjustment during
linkage.
Correct the maximum steering angle and left and right steering angles when there is a difference in the
turning radius due to the characteristics, etc. of the vehicle.
Setting item (channel and direction)
ST-LFT: Steering (left)
ST-RGT: Steering (right)
TH-FWD: Throttle (forward)
TH-BRK: Throttle (brake)
3C-LFT: 3rd channel (left)
3C-RGT: 3rd channel (right)
4C-UP: 4th channel (up)
4C-DWN: 4th channel (down)
Steering EPA Throttle EPA
ST-LFT:0%~120% TH-FWD:0%~120%
ST-RGT:0%~120% TH-BRK:0%~120%
Initial value:100% Initial value : 100%
Aux Servo EPA Aux Servo EPA
3C- LFT:0%~120% 4C-UP:0%~120%
3C-RGT:0%~120% 4C-DWN:0%~120%
Initial value: 100% Initial value: 100%
End point adjustment
(1) Access the function menu (By pressing “Exit” and “Enter” buttons simultaneously and holding them down
for one second),press “Inc(+)” button twice to chose EAP function.
(2) Press “Enter” button to get into EPA function interface, use “Dec(-)” or “Inc(+)” button to select the desired
setting item , press “Enter” key, the initial value of your selected setting item will blink, then you can press
“Dec(-)” or “Inc(+)” button to adjust the value of your selected setting item.
(Note: In the interface of adjusting the value, return to the initial value "100%" by pressing “Dec(-)” and “Inc(+)”
buttons simultaneously for about 1 second.)
3. Press “Enter” button, the adjusted value of your selected setting item stops blinking, now the value of your
selected setting item has been set.
4. Return to the initial screen by pressing “Exit” button twice.
2.5 Steering EXP "STEXP"
This function is used to change the sensitivity of the steering
servo around the neutral and both ends position. It has no effect
on the maximum servo travel.
Adjust the sensitivity of direction wheel both in neutral position
and ends.
Setup Item
RATE: Steering EXP rate
Adjustment range