Manual

RadioLink Electronic Ltd
www.radiolink.com
6
Model Name
The system can store the data for 10 models, model name will show on the LCD when you power on the
transmitter. Please make sure the model name is the right one that you want.
If the model name you chose is not corresponding with your model, the settings should be wrong.
Transmitter Voltage
In addition to the model, LCD can show the voltage of battery. When the voltage is lower than 4.6V, it would
start the low-voltage alarm, it would send out “DDD…” sounds, till the transmitter is power-off. When you hear
the low-voltage alert, you have no more than 4 minutes for controlling your model, please safely stop your
model before the uncontrolled situation. Please make sure the battery voltage is higher than this voltage data
while radio controlling.
Transmitter function menu setting
When you want to browse or change a setting of transmitter, you should go into function menu setting mode.
Under function menu setting mode, you can set up Language. Select "LANGUAGE" , Model Select "MODEL",
End Point Adjuster "EPA", Steering EXP "STEXP", Steering Speed "STSPD", Throttle EXP "THEXP", Throttle
Speed "THSPD", A.B.S. Function "A.B.S", Throttle Acceleration "ACCEL", Idle-Up "IDLUP", Sub-trim
"SUBTR", Servo Reverse "REV", Steering Dual Rate/Second. Dual Rate "D/R", ATL Function "ATL",
Programmable Mixes "PMIX", Auxiliary, Channel 3 and 4 "AUX" ， Model name "NAME", Reset function
"RESET".
2.2 Language Select "LANGUAGE"
Both English and Chinese version menu are available for which
Is convenient for Chinese and English-speaking players to
personalize function menus.
(1) Access the function menu (By pressing “Exit” and “Enter”
(2) buttons simultaneously and holding them down for one second),
the Language select function will be chosen.
(2) Press “Enter” button to get into “LANGUAGE” function interface.
(3) Use“Dec(-)”or “Inc(+)”key to select “
中文
”or “English”, the
selected language will be with black shading effect.
(4) Press “Enter” button, the desired language is selected, and return
to the initial screen automatically.
2.3 Model Select "MODEL"
RC4GS can store model memories for ten models. Use this function to
call a new model.
(1) Access the function menu (By pressing “Exit” and“Enter” buttons
simultaneously and holding them down for one second), press “Enter”
key once, the Model select function will be chosen.
(2) Press “Enter” button, the current active model will be blinking.
(3) To activate a different model by pressing “Dec(-)” or “Inc(+)” button
until the desired model blinks.
(4) Press “Enter” button, the selected model stops blinking, now the
model has been selected.
(5) Return to the initial screen by pressing “Exit” button twice.
2.4 End Point Adjuster "EPA"
Use EPA when performing left and right steering angle adjustments, throttle high side/brake side