User Manual

82
Goals
Steps
Inputs
Select proper MODEL
TYPE. (Ex:
MULTIROTOR）
Open BASIC menu, find
MODEL TYPE.
Turn on the transmitter, for 1 sec. to BASIC
menu (If ADVANCE, again)
to MODEL TYPE
Go to MODEL TYPE
to TYPE
Choose proper model type
(Ex: MULTIROTOR).
Confirm the change.
to MULTIROTOR, for 1 sec. ‘Are you sure?’
Displays, to confirm.
Turn on the trim.
to AILE-TR , to ON.
Repeat above to turn on other trims
Close
6.1.2 AUX Channel setting
AUX channel for MULTIROTOR is channel 6 to 10, same like ACRO, GLID and HELI, to set auxiliary
channel. CH5 is special for ATTITUDE, enter CH5 and press PUSH for ATTITUDE. Select 3-section and
2-section switch to get 6 different attitudes. By DIAL set 6 different rates according to the attitudes.
6.2 ADVANCE MENU FOR MULTIROTOR
6.2.1 ATTITUDE
There are 6 different attitude modes for MULTIROTOR: NORMAL, ATTI, GPS, HOVER, F/S and AUX.
Every mode will have a different rate to get a unique signal. NORMAL mode preset 0%, ATTI 50%, GPS
100%, HOVER 25%, F/S 75% and AUX 50%.
0% means a output signal 1ms, and 100% means 2ms. You can totally get 6 different modes by adjusting the
related rates.
Goals
Steps
Inputs
Set the
ATTITUDE of
MULTIROTO
R.
In ADVANCE menu find the
ATTITUDE function.
urn on the transmitter, for 1 sec. to BASIC
menu (If ADVANCE, again)
Press MODE to ATTITUDE
Assign the switch to control attitude.
Ex: SW3 is SWC，SW2 is SWB
to SW3, , to SWC，
to SW2, , to SWB，
Set the rate in each attitude.
Ex: ATTI is 60%.
to rate-ATTI, ， to 60%，
Close
6.2.2 THROTTLE CURVE (see ACRO 3.3.14)
6.2.3 PROG. MIX (see ACRO 3.3.1)