User Manual

77
additional channel and a programmable mix.
The GV-1 controls throttle when it is active, so the throttle will not obey any Failsafe settings preset for
throttle in the transmitter. Always set the Failsafe setting for the GV-1's on/off channel to OFF. This way
the governor is shut off and the throttle obeys the Failsafe throttle commands.
Goals
Steps
Inputs
Set up a governor to use
both channels into the receiver
and switch between the
governor settings
automatically when changing
conditions. Consider setting the
battery Fail Safe settings and
other helpful functions on the
governor itself.
Open and activate the
GOVERNOR
Function.
to BASIC menu, again to
ADVANCE
to GOVERNOR
Activate the function.
to MIX ， to ACT.
Optional: change cut-off
channel to channel 8 and
assign switch and direction
for on/off (channel 8).
to -cut- CH: ， to+CH8，
to -cut-SW ， to desired SW
Optional: Changes switch
assignment to select governor
settings.
Ex: select switch that
selects the conditions.
to SW ， to Cond，
Adjust governor speed
settings per switch position
or condition as needed.
(Ex: defaults are fine.)
Allows head speed
adjustment from transmitter.
to each Cond position or as
needed.
to next Cond，repeat .
Close
5.3.10 Throttle Mixing (THROTTLE MIX):
This function can be set for each flight condition, and is used to correct the tendency of the model to change
altitude when the rotor is tilted by aileron, elevator, and rudder controls.
ADJUSTABILITY:
• Mixing may be set from 0 to 100% each flight condition.
Goals
Steps
Inputs
Correct the tendency
of the model to
change altitude.
Open
THRO- MIX
function.
to BASIC menu, again to ADVANCE
to THRO-MIX
Activate the function.
to MIX , to ON
Adjust the rate.
Ex:
IDL1
(AIL to TH) 10%
to IDL1 (AIL→TH) , to 10%,