User Manual

75
Goals
Steps
Inputs
Set up separate
trims for each of the
three idle-up
conditions.
Adjust the idle-up
2 rudder trim to
correct for torque at
high speeds.
Open the
OFFSET
function.
to BASIC menu, again to ADVANCE
menu
to OFFSET.
Activate the function.
to MIX , to ON.
Change switch setting to
Cond
.
to SW , to Cond，
Select
IDL2
.
to NO. , to IDL2,
Adjust trim settings as needed.
(Ex:rudder to
+8%
.)
to RUDD , to +8%，
Close menus and confirm
slowed transitions.
E (AT10II) from NORMAL to IDL2.Check the
changes of rudder trim.
5.3.8 DELAY:
The Delay function provides a smooth transition between the trim positions whenever OFFSET, REVO,
MIXING, or THROTTLE HOLD functions are turned on and off.
ADJUSTABILITY:
• Separate delay times are available for aileron, elevator, rudder, throttle, and pitch.
• With a 50% delay setting, the servo takes about a half-second to move to its new position, quite a long
time.
• In general, delays of approximately 10-15% are sufficient.
Goals
Steps
Inputs
Set up a delay on all
channels to ease the
transition from one flight
condition to another so
there are no ‘hard
jumps’.
Open the
DELAY
function.
to BASIC menu, again to ADVANCE
to DELAY
Adjust
AILE response
as
needed. (Ex: aileron to
+8%
.)
to RATE-AILE , to 8%,
Repeat for other channels.
to ELEV. Repeat steps above.
Close menus and confirm
slowed transitions.
E(AT10II) from NORMAL to
IDL2.Check that the servos move gradually to
new positions.