User Manual

71
Hover point: Adjust
collective pitch curve to +5
degrees. Ease heli into a
hover. Land/shu t engine
off. Adjust throttle curves
and rudder trim. Repeat until
model hovers smoothly at
half throttle. Rapidly apply
throttle from 1/4 to 1/2
stick. Adjust
REVO
.
points 2 and 3
until the model does not rotate
its nose up on throttle
application.
Adjust
THR-CURV/NOR
Repeat above as needed
Adjust
PIT-CURV/NOR
Repeat above as needed
Adjust
REVO.MIX
Repeat above as needed
High point: Adjust
collective pitch curve to +8
to +10 degrees. From hover,
throttle up rapidly. If
engine bogs, increase the
throttle curve. If engine
over-revs, increase the
collective pitch curve at points
6 or 7. Apply full throttle
while hovering, then descend
back to
hover. Adjust
REVO
.
until the nose does
not change
heading.
Adjust
THR-CURV/NOR
Repeat above as needed
Adjust
PIT-CURV/NOR
Repeat above as needed
Adjust
REVO.MIX
Repeat above as needed
5.3.3 GYRO SENSE
About GYRO SENSE, please refer to 3.3.12, by following steps:
Goals
Steps
Inputs
Set up heading-
hold /AVCS gyro
with
heading-hold/AVC
S setting in
idle-ups 1 and 2
and normal mode
Open and activate the GYRO
SENSE function.
for 1s to BASIC.(If ADVANCE
again) .
to GYRO-SENSE
Activate the function.
to MIX , to ACT.
Optional: Change gyro types to
Heading- hold
(
GY
).
to MODE , to GY
Optional: Changes switch
assignment.
Ex: select
Cond
.
to SW , to Cond