User Manual

61
Elevator setting is
adjustable in the
B.FLY-ELE.
MIX switch is selectable
Activate the function
SWA to UP position
to MIX , to OFF
Adjust the travels as
needed.
(Ex: Aileron each 75%, Flap
75%)
to AIL1 , to 75%，
to FLP , to75%，
to AIL2 , to 75%，
Close
4.3.9 AILE/ RUDD MIX
You can select a pre-programmed mix which is used to mix the rudders with aileron operation or the ailerons
with rudder operation.
Aileron-to-rudder mix (AILE􀀒RUDD): automatically creates a "coordinated turn".
Rudder -to-aileron mix (RUDD􀀒AILE): used to counteract undesirable roll (roll coupling) that happens with
rudder input, especially in knife-edge.
ADJUSTABILITY:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron
(rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the
mix in 2 separate positions of the same SWITCH.
• Condition: The separate AILE􀀒RUDD setting for each flight condition can be set.
Goals
Steps
Inputs
Ex:RUDD-AILE,
25%,no switch,
corrects roll
coupling.
Open AIL/RUD-MIX
submenu.
to BASIC . again to ADVANCE
to AIL/RUD-MIX,
Select the mixing mode.
to MODE , to RUDD-AILE
Activate the function
to MIX , to ON
Set the rate (Ex:100%
each way)
to RATE
RUDDER STICK , to +25%
RUDDER STICK , to +25%
Close
4.3.10
ELEV-FLAP mixing (see GLID menu 3.3.7)
4.3.11 AILE-FLAP(GLID 2A+2F only):
This pre-programmed mix is used to create full span aileron action on a glider
with 4wing servos. This increases the roll rate and decreases induced drag. For normal flying, a value of