User Manual

Note: The same delay amount for elevator and rudder is recommended when using V-tail function.

ADJUSTABILITY:

• Delay time (-DLY-) range of 0 to 100%. The delay time is 10 second at 100%.

Goals

Steps

Inputs

Ex: delay time=5

second.

Open ADVANCE menu,

then open START DELAY.

to BASIC . again to ADVANCE

to START-DLY,

Activate the function

to MIX , to OFF or ON

Set the delay time.

(Ex:50% each surface)

to ELEV , to 50%

to RUDD , to 50%

Repeat as needed.

4.3.6 CHAMBER-FLP

CAMBER FLAP assigns the primary flap control [defaults to VR (A)] to allow trimming in flight of the flap

action. The up and down travel of each flap (camber flaps: FLP1/2) can be adjusted independently. Also the

center position of flap servo can be offset.

Note: If FLAP-TRIM is activated, you can not use CAMBER FLAP function simultaneously.

ADJUSTABILITY

• Rate: -100% to +100%, with a default of +30%

• Center position (CENTER): The operation reference point of flap can be offset. -100% to +100%, with a

default of 0%.

Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after

pressing DIAL for 1 second and canceling an alarm display.