User Manual

ACRO GLID

ELEV-FLAP mixing is the first pre-programmed mix we'll cover. This mix makes the flaps drop or rise

whenever ELEVATOR STICK is moved. It is most commonly used to make tighter pylon turns or squarer

corners in maneuvers. In most cases, the flaps droop (are lowered) when up elevator is commanded.

Adjustability:

• Rate: -100% (full up flap) to +100% (full down flap), with a default of +50% (one-half of the flap range is

achieved when the ELEVATOR STICK is pulled to provide full up elevator.)

• Switch: Fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. IF you set it to NULL, the mix

does not work. (ACRO)

•Range (GLID): The range that mixing does not work near neutral of an elevator stick can be set up. Hold

the stick to the desired point (upper or lower side) , then press DIAL and hold one second to set the range.

• Condition (GLID): The separate ELEV-FLAP settings for each condition can be set.

Goals

Steps

Inputs

Activate ELEV-FLAP

mixing. Adjust flap

travel to 0% flaps with

negative elevator

(push) and 45%flaps

with positive elevator.

Open ELEV-FLAP

to BASIC . again to ADVANCE

to ELEV-FLAP. PUSH.

Activate the function

to MIX,PUSH. to ON.PUSH

Adjust the travels as

needed. (Ex:0%, to45%)

to RATE.

Elevator Stick to 0%，

Elevator Stick

to + 45%,

3.3.8 Dual Elevator Servos (with a rudder) (AILEVATOR) (ACRO):

Many models use two elevator servos, plugged in separate receiver channels. (Flying wings without a