User Manual

•ALWAYS set the student transmitter modulation mode to PPM.

• BE SURE that the student and instructor transmitters have identical trim settings and control motions.

Verify by switching back and forth while moving the control sticks.

• FULLY extend the instructor's antenna. Collapse the student's antenna. (Except 2.4GHz)

• When the TRAINER function is active, the snap roll function is deactivated. Other functions, such as

IDLE-DOWN and THR-CUT, which have been assigned to the same switch, are not deactivated. Always

double check your function assignments prior to utilizing the TRAINER function.

•When you select a different model, the TRAINER function is deactivated in the current model for safety

reasons.

Goals

Steps

Inputs

Turn on the TAINER system

and set up so student has :fully

functional control of aileron

and elevator to support

FLAPERON &AILERON;

normally control of rudder to

allow lowered travel; and no

throttle channel control(with

the instructor for safety)

Open BASIC menu, then Open

TRAINER

for 1s .(If ADVANCE again) .

to TRAINER ,PUSH

Activate TRAINER

PUSH, to PUSH

Choose desired channels and

proper training types

past AILE and ELE(default FUN)

to THRO,PUSH， to OFF, PUSH

to RUDD, PUSH, to

NORM,PUSH

Test student radio function prior to attempting to fly!

2.3.14 Logic Switch Selection (LOGIC SW):

The various functions in the AT10II can be selected by switch..

The Logic switch can be assigned to the functions as following: THR-CUT, IDLE DOWN, AUX-CH,

TIMER, PROG. MIX, AIRBRAKE, ELEV-FLAP, and AILE-FLAP. The logic switch can activate functions

by two switches combination. The 2 types of logic, either AND or OR, can be selected.

Adjustability:

• Three logic switches can be used. (LSW1, LSW2, and LSW3 )

• SW (1): Any SWICH A-H or THRSTKS, SW (2): Any SWICH A-H

• Switch position (POSI)

• Logic mode: AND or OR (MODE)

2.3.15 SERVO display and cycle sub-menu:

Displays radio's output to channels 1-12.