User Manual

30
activated later by a
throttle to CH7 MIX).
Repeat above steps as desired.
(Ex:CH7=NULL)
to CH7,PUSH, to NUL
Close
2.3.12 TIMER sub-menu (stopwatch functions):
Controls three electronic clocks used to keep track of time remaining in a competition time allowed, flying
time on a tank of fuel, amount of time on a battery, etc.
【TIMER】
<1>OFF
<2>OFF
<3>ON
TIME：10:00
10:00
---
MODE：UP
UP
MODEL
ON:
SwA
SwA
---
NULL
NULL
---
RSET：
SwA
SwA
---
NULL
NULL
---
Adjustability:
• Count down timer: starts from the chosen time, displays time remaining. If the time is exceeded, it
continues to count below 0.
• Count up timer: starts at 0 and displays the elapsed time up to 99 minutes 59 seconds.
• Count down timer (Stop type): starts from the chosen time, displays time remaining, and stops at 0.
• Model timer: cumulates ON time up to 99 hours 59 minutes each model. Once Model timer function is
turned off, the cumulate time will also be reset to "0:00".
• Independent to each model, and automatically updates with model change.
• In either TIMER mode, the timer beeps once each minute. During the last twenty seconds, there's a beep
each two seconds. During the last ten seconds, there's a beep each second. A long tone is emitted when the
time selected is reached. (UP/DOWN TIMER)
• To Reset, choose the desired timer with the CURSOR lever (while at the start-up screen), then press and
hold DIAL for 1 second.
• Activation by either direction of SWITCH A-H, by THROTTLE STICK (STK-THR) (Using the
THROTTLE STICK is convenient if you are keeping track of fuel remaining, or for an electric, how much
battery is left), by LOGIC SWITCH Lsw1-Lsw3 or by the power SWITCH (PWR SW).
• Also the reset switch can be assigned (SWITCH A-H or LOGIC SWITCH Lsw1-Lsw3)
Goals
Steps
Inputs
Set timer 2 to count
down 4 1/2 minutes,
being controlled by
Throttle Stick position.
This utilized to keep
track of actual Throttle
on time to better
cooperate with
fuel/battery usage.
Open BASIC menu, then to
TIMER
for 1s .(If ADVANCE again) .
to TIMER ,PUSH
Go to TIMER <2>
to TIMER <2> ，PUSH