User Manual

29
Goals
Steps
Inputs
Change the receiver
Failsafe command for
channel 8(gasoline engine
kill switch) to a preset
position. NOTE: This is
one of several functions for
which the radio requires
confirmation to make a
change.
Open BASIC menu, then
Open F/S.
for 1s .(If ADVANCE again) .
to F/S, PUSH
Choose channel to
change(Ex:CH.8)
to CH8 ,PUSH
Set and confirm fail safe
command.
that controls CH8 to desired OFF position.
to adjust ,PUSH
Repeat as desired
Close
2.3.11 Auxiliary Channel Function (including channel 9-12 controls)
(AUX-CH): defines the relationship between the transmitter controls and the receiver output for channels
5-12. Also, the CH9-12 POSI are used to change the CH9-12 servo direction.
Note that the CH9-12 functions are only visible in the AUX-CH screen and modulation mode must be PCM
or 2.4G.
Adjustability:
• channels 5-8 may be assigned to any SWITCH (A-H), LOGIC SWITCH (Lsw1-Lsw3), slider [VR(D)
and VR(E)], or knob [VR(A-C)] (for example, moving flaps to a switch or slider), but not the primary
control sticks (use programmable mixes to do so);
• channel 9-10 may be assigned to any SWITCH (A-H), LOGIC SWITCH (Lsw1-Lsw3) and the servo
direction may be changed.
• multiple channels may be assigned to the same switch, slider or knob;
• channels set to "NULL" are only controlled by mixes. (Ex: utilizing 2 channels for 2 rudder servos. See mixes
p. 68.)
• If GYRO SENSE, GOVERNOR, and THR-NEEDLE functions are activated, AUX-CH settings of related
channels become invalid automatically.
【AUX-CH】
CH1：STK1
CH2：STK2
CH3：STK3
CH4：STK4
CH11：SwD
CH12：VrE
CH5：SwG
CH6：VrA
CH7：VrC
CH8：VrB
CH9：SwB
CH10：SwA
Related channels:
GYRO SENSE (ACRO): CH. 5, 7, or 8
GYRO SENSE (HELI): CH. 5
GOVERNOR (HELI): CH. 7, or CH. 7 and 8
THR-NEEDLE (ACRO􀀒HELI): CH. 8
Remember that if you assign primary control of a channel to a switch which you later use for other
functions (like dual/triple rates or airbrakes), every time you use that other function you will also be moving
the auxiliary channel.
Goals
Steps
Inputs
Assign flaps to the right
slider[VR(E)] and set
channel 7 to NULL in
preparation to use it as a
smoke system control
(the smoke system being
Open BASIC menu, then to
AUX-CH
for 1s .(If ADVANCE again) .
to AUX-CH,PUSH
Choose channel to change (Ex:CH6)
to CH6，PUSH， to desired switch,
PUSH