User Manual

25
(HELI) press the CURSOR LEVER to toggle through the 5 conditions while setting the rates.
(GLID) activate the corresponding condition to edit the rates.
Goals
Steps
Inputs
Set up dual rates
and exponential in
HELI model.
Open D/R,EXP
for 1s.(If ADVANCE again)
to D/R EXP,PUSH.
Choose channel
to CH, Push. to desired channel. PUSH
Choose first channel position
to NO,PUSH. to UP,PUSH.
Set rate and EXP(Ex: High
rate=95%,0%exponential)
to Rate, PUSH. to 95%,confirm 0% EXP.
Go to 2nd switch position and
set rate and exponential.
to NO,PUSH to DOWN,PUSH.
Optional: if using a 3 position
switch, set 3rd rate.
to NO,PUSH. to COND repeat above.
Optional: assign dual rates to
have one for each condition.
to SW,PUSH. to COND.
Repeat steps above to adjust for each condition.
Goals
Steps
Inputs
Set up aileron triple rates on
SWITCH C with travel
settings of 75%(normal)
25%(slow roll)and 140%
(extreme aerobatics)and
exponential setting of
0%, +15%, and -40%
respectively.
NOTE: This normal rate has
no exponential so it has a
Very linear, normal feel.
This is slow roll rate has
positive exponential
(the opposite of what most
people normally uses),
which makes the servos
more responsive around
center. This makes the servos
feel the same around center
in the normal and low rates,
but still gives a very slow
roll rate at full stick.
3D rate (extreme aerobatics)
has a very high distance of
travel nearly twice that of the
normally rate.
Therefore, using a very high
rate negative exponential
setting softens how the servos
responses around center stick.
Open D/R,EXP
f
o
r
1
s
t
o
B
A
S
to D/R,EXP,PUSH.
Choose channel to change
(Ex:aileron is already selected)
to CH,PUSH， to AILE,PUSH
Optional: Change switch position.
to SW,PUSH to SWC,PUSH
Confirm switch is in desired
position and set rate.(Ex: up=high
rate,75%)
to D/R C to UP position.
AILERON STICK to75%.PUSH
AILERON STICK to75%.PUSH
Move Switch to 2nd rate position
and set this particular rate (Ex:
center=low rate,25%)
SWC
to center position, to D/R
AILERON STICK to 25%，PUSH
AILERON STICK to 25%，PUSH
Optional: If using a 3 position SW,
move SW to 3rd position and set
this rate.(Ex: DOWN=3D rate,
140%)
SWC to DOWN position.
AILERON STICK to 140%，PUSH
AILERON STICK to 140%，PUSH
Optional: except using a switch,
you can set high rates to be
triggered when the stick moves
past a certain point. To test this,
set aileron high rate to 25%.Now
set switch assignment to AIL
(90%). Move AILERON STICK to
the right and notice the huge jump
in travel after the stick moves 90%
of its distance.
to SWA to AILE(90%)
,
PUSH
to D/R
AILERON STICK to 25%
AILERON STICK to 25%
AILERON STICK and watch screen
graph. See the change? You may also
change the trigger point by holding the stick
at the desired point then pressing and
holding the PUSH.